Place the spool in the frame and check that the gap between the frame ring and the front spool plate is even all the way around.
IMPORTANT: If the gap is not even, slightly loosen all five binding head screws that attach the front ring to the pillars and move the front ring until the gap is even.
IMPORTANT: If the spool still rubs after centering you need to sand the edges of the spool plates and the inside of the frame rings some more to round them over properly. Also, make sure there are no nubs on the inside of the rings.
Carefully tighten the five screws, ensuring that the gap remains even.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.