Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Module 5: Spool Front and Handle
[* blackicon_note] ++PREP NOTE:++ if you'd like the exposed side of your spool plate to be untextured, you will need to sand off the textured finish. Lightly sand with 320 grit, then complete with 400 and 600 grit sandpaper and polish.
[* blackicon_note] ++PREP NOTE:++ if you'd like the exposed side of your spool plate to be untextured, you will need to sand off the textured finish. Lightly sand with 320 grit, then complete with 400 and 600 grit sandpaper and polish.
[* black] Insert the '''flat head screw''' so its head fits into the countersink.
[* black] The second photo shows the proper orientation for the '''handle bolster'''. Note that the countersunk side faces towards the '''spool plate'''.
[* black] ''NOTE: This step is important, ificon_caution] IMPORTANT: If you install the bolster the wrong way, the handle will not rotate freely.''freely.
[* black] ''NOTE: This step is important, ificon_caution] IMPORTANT: If you install the bolster the wrong way, the handle will not rotate freely.''freely.
[* black] The last photo shows how the '''handle spindle''' screws onto the '''flat head screw'''. Tighten this screw snugly.